I recently turned on the time-lapse feature of my Octopi Octoprint server just to see how it went. Below is the video showing you printing these two objects on my Creality Ender 3 3D Printer. There’s a Kiwi bird pen …
Monthly Archives: March 2019
Ender 3 All-in-one Micro test
Posted by Jason Oakley
on March 17, 2019
No comments
One of the best ways to test out your printer is to do a Micro All-in-one test print. It makes your printer print overhangs up to 80 degrees along with bridge printing, stringing test, sharp-corner test, tolerence and scale tests.
Fixing a problem with filament feeding
Posted by Jason Oakley
on March 16, 2019
5 comments
I’ve been annoyed for the last week as my Ender 3 was not printing anything. It’d worked so well for a while, then all of a sudden no filament would come out.. or just a little bit would dribble out. …
Octoprint with Logitech c170 webcam
Posted by Jason Oakley
on March 6, 2019
No comments
I finally have webstreaming working with my Octopi/Octoprint server and I can watch the stream of my Creality Ender 3 3D printer.
PokerStars VR
Posted by Jason Oakley
on March 3, 2019
No comments
I played Poker VR extensively and so thought I’d give PokerStars VR a whirl. It’s similar to Poker VR in some ways, but in others it’s different. To begin with, there doesn’t seem to be any tutorials which is annoying …
