Printed case for Raspberry Pi Jason Oakley, February 24, 2019February 24, 2019 After about 30 attempts I managed to successfully print a nice case for my Raspberry Pi. It’s the Snap Fit Case. Failed attempt I have tried so many times to print this but it always failed and I was very frustrated. The little stand part on the left-front would always eventually slip off the base plate and ruin the print. Sometimes only after 15 mins of printing. I posted on Reddit and Facebook a few times and did a lot of research. In the end I got it to work by: Printing at half the original speed – especially the initial layer (set to about 15)Enable Raft and SupportsApply sugar water and a squirt of hairsprayFlip the Creality print bed and print on the back of it Time-lapsed successful print As you can see in the time-lapse video above the print was successful. In fact, it finished sooner than I expected. (And sooner than Octoprint expected). Part-way through printing The finished print with raft and supports Raft and supports removed Top and bottom printed previously Completed assembly After all this I’m very happy to finally have my case printed successfully. I’ve learned a lot but I know I have a long way to go. Next is getting the camera to be recognised by Octoprint, then printing a case and mount for it. 3D Printing
Fixing a problem with filament feeding March 16, 2019March 16, 2019 I’ve been annoyed for the last week as my Ender 3 was not printing anything…. Read More
Printed Fitbit Ionic charging stand February 25, 2019February 25, 2019 I asked a friend to print one of these about 1.5 years ago and I’m… Read More
XYZ Calibration cube February 3, 2019February 3, 2019 I’ve recently purchased a Creality Ender 3 3D Printer and have run a few tests… Read More